Early wiper motor ID Fj40 (1 Viewer)

[thundermcawesum]

Hi guys. What do I have here?

Scored a pair of early motors I want to fix up. I am wondering if I have a mismatched pair LHD and RHD?

I was reading this thread and I am still confused:

Some info on Early Wiper Motors

I never installed my wipers after finishing my build/restoration. I'm finally getting around to it now. I did a lot of searching around MUD but couldn't find info on wiring early OEM motors (stamped TNK) without the factory harness. So here's what I learned today tearing early wiper motors...

forum.ih8mud.com

Wiper 1
Slotted screws (??)
Smooth output shaft
I think the rotor cover was put on upside down because the drain port faces up when contacts are to the right (see below)

 

[thundermcawesum]

Wiper 2

Phillips screws
Cool sticker still present (ISO)
Threaded output shaft

 

[tahoe40/45]

They both look to be correct early TNK wiper motors, 1961 to 1967 FJ40/45s. The one with slotted screws is an early version, philips head screws is later version. Yes cover is probily upside down. Can you post a photo of both output shafts?

 

[thundermcawesum]

They both look to be correct early TNK wiper motors, 1961 to 1967 FJ40/45s. The one with slotted screws is an early version, philips head screws is later version. Yes cover is probily upside down. Can you post a photo of both output shafts?

Early version output shaft

 

[thundermcawesum]

They both look to be correct early TNK wiper motors, 1961 to 1967 FJ40/45s. The one with slotted screws is an early version, philips head screws is later version. Yes cover is probily upside down. Can you post a photo of both output shafts?

Late output shaft. I’m thinking someone replaced with shelf part

 

[tahoe40/45]

Late output shaft. I’m thinking someone replaced with shelf part
View attachment 3551395

Yeah, that looks modified by PO.