AZ NO-Bull Bar Phase II (1 Viewer)

[TroutBear]

"Phase 2 started with some shackle points from 4x4 labs. "

Are these shackle points bolt on to the frame or weld on tab types? We have a plywood mock up made for some rear points that need to be transfered to 3/4 x 3 plate steel - bolt to inside of frame and extend through slots cut into stock bumperettes. I looked for some to buy before doing this and would still be interested before having a pair milled out.

 

[MaddBaggins]

"Phase 2 started with some shackle points from 4x4 labs. "

Are these shackle points bolt on to the frame or weld on tab types? We have a plywood mock up made for some rear points that need to be transfered to 3/4 x 3 plate steel - bolt to inside of frame and extend through slots cut into stock bumperettes. I looked for some to buy before doing this and would still be interested before having a pair milled out.

They are the same ones he sells for his 80 series rear bumper. They weld on. In this case I also drilled a hole thru them so that one of my bumper mounting bolts on each side goes thru it. I also cut about 1" off the total length to fit my application.

 

[TrAiLbUs1]

That looks super tough bro, nice jobHave fun in payson big guy