So my used compressor locked up. I installed a new Denso compressor, Denso receiver dryer, new (non oem) expansion valve.
I get everything buttoned up, pull a vacuum and it looks good to go. Hook the can up to the gauges, start it up with the AC on high and it didn't go as planned.
The clutch engaged and it started taking 134a. Can got cold but it only took about 1/4 of the first can. The low side pressure went really high and the high side pressure was the same as low side.
Now I'm trying to figure out if it's a bad new compressor or a problem with the expansion valve.
Any thoughts?
I get everything buttoned up, pull a vacuum and it looks good to go. Hook the can up to the gauges, start it up with the AC on high and it didn't go as planned.
The clutch engaged and it started taking 134a. Can got cold but it only took about 1/4 of the first can. The low side pressure went really high and the high side pressure was the same as low side.
Now I'm trying to figure out if it's a bad new compressor or a problem with the expansion valve.
Any thoughts?