This has not been a good couple of days for the Cruiser. After changing my tstat over the weekend and chasing down my low voltage problem, now I’ve got all five of these ABS/traction lights on. They popped on this afternoon while driving. No alarm, and no CEL.
Brake performance is fine, and the ATRAC system is not activating. In fact, car drives perfectly normal. The brake pump/accumulator repressurizes in 37 seconds from a full bleed-down, so no issue there. What is puzzling abs frustrating is that I can’t seem to get it to display an ABS code. I jumpered the engine bay diagnostic port, but neither the ABS light nor the VSC lights blink. Of course, there are no OBD codes present.
Does this indicate a bad ABS computer, as others have experienced? Any reason why I can’t get the codes via the jumper method, or alternative methods to try. As always, thank you sincerely in advance.
Brake performance is fine, and the ATRAC system is not activating. In fact, car drives perfectly normal. The brake pump/accumulator repressurizes in 37 seconds from a full bleed-down, so no issue there. What is puzzling abs frustrating is that I can’t seem to get it to display an ABS code. I jumpered the engine bay diagnostic port, but neither the ABS light nor the VSC lights blink. Of course, there are no OBD codes present.
Does this indicate a bad ABS computer, as others have experienced? Any reason why I can’t get the codes via the jumper method, or alternative methods to try. As always, thank you sincerely in advance.