9.5" diff armor, it does exist! (1 Viewer)

[bwakeling]

Any install pics? I’d love to see how these turned out.

sitting in the garage. its -30 c here so not doing much till it warms up.

 

[spyduh]

Ballistic Fab has fj80 9.5 diff armor.

I have one. Was easy to weld but took forever. Lots of places to burn in Good quality and took a beating at the hammers last week.

 

[zidaro]

the ballistic fab rear 80series 9.5 guard i received fit like crap. every bend in the wrong place or angle. Had to literally cut it into pieces then reweld to fit.

 

[Road Apple]

Here’s the Moto Farkle lower plate burned in. The 1/4” steel isn’t thick enough to cover the drain very well, even with a bead built up around it. Planning to add some scrap to both sides of the drain plug.

 

[spyduh]

Here’s the Moto Farkle lower plate burned in. The 1/4” steel isn’t thick enough to cover the drain very well, even with a bead built up around it. Planning to add some scrap to both sides of the drain plug.

you should have bought the ballastic fab lower plate. It goes way over the factory ring. See the pics in crawler build thread.

 

[Road Apple]

you should have bought the ballastic fab lower plate. It goes way over the factory ring. See the pics in crawler build thread.

I bought the Moto Farkle awhile back not knowing about the Ballistic. I bought one from Ballistic for the front though. Wish I had know about the Ballistic front plate like @jcardona1 has on his rig before mounting the Trail Gear plate too. Strike 2

 

[spyduh]

Front. Ballastic 8 lower And half cut marlin 8 cover.

Rear Ballastic 9.5

 

[richardlillard1]

What about armor for the rest of the axle?

 

[jcardona1]

What about armor for the rest of the axle?
View attachment 2640264
View attachment 2640265

 

[stewtopia]

Front. Ballastic 8 lower And half cut marlin 8 cover.

Rear Ballastic 9.5

View attachment 2640235

View attachment 2640244

That looks great! What was the SKU of the rear Ballistic?

 

[baldilocks]

Front. Ballastic 8 lower And half cut marlin 8 cover.

Rear Ballastic 9.5

View attachment 2640235

View attachment 2640244

I meant to ask if that diff guard has a large drain hole at the bottom because it looks like it would be a reservoir for debris.

 

[GOTLOCKED96]

If you are in the Sacramento area, this is what StellarBuilt is cooking up on my 80 build. @eurosonic

 

[highsierra4x4]

you should have bought the ballastic fab lower plate. It goes way over the factory ring. See the pics in crawler build thread.

Any pics