Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
...what work did you do to the end support plate aside from welding the tabs for the brace bars? Zerk fitting.. quality bushing...maybe a seal? I was hoping to see the steps involved in that.
How did you get the knob off of the shaft that engages the motor vs. neutral? In other words how did you remove part # 2 from part # 5? Mine is not going anywhere!
Drill and pin free spool / to prevent accidental free spool.
Can someone explain how this mod is done so I can better understand it? Another question: What weld rod are people using to weld on aluminum plugs for drain and fill? 4043? Thank you.
in reading though this thread i don't see anywhere about the concave washers being used in the brake assembly. mine didnt have any in it when i took it apart but the rebuild kit has three concave washers in the kit? do they get used on the older winches or are they for something different?