hoping to figure out what plug on the harness goes to the temperature switch to actuate the carb fan. I had hoped my Feb80 FJ40 matched a 82 I got but the plug from the 82 doesn’t match my 80 harness.
I’ve researched off and on and seen a lot of threads on the carb fan but haven’t figured...
Gday everyone I would just like some ways of troubleshooting my temperature gauge (1979 fj45 2f) it does not move at all along with my oil pressure and alternator gauge. So far the only trouble shooting I have done is removing the temp sender, visual inspection (looked good) checked resistance...
Hey guys,
So I live in Florida and my temperature gauge always warms up in what I believe to be a normal range. I’m traveling up in the northern states atm where the temperatures are around 32f (0c) to 40f (4c). And my temperature gauge will barely rise driving around town unless I hop on the...
I guess I’d understood from all the great info here that fusible links failed for mechanical reasons, etc., but hadn’t really understood they could fail in an intermittent way that would make them darn hard to troubleshoot.
Short story is my LX450 developed an issue where the engine bay got...
I am curious about this dash light on my cluster above the charge light
Google translate says it is "hot exhaust". Is this a factory EGT warning lamp? I'm curious on where I can get a sensor to trip this light. I'm in the process of getting everything working as factory on my truck again and...
So my radiator started leaking pretty severely, so it needed to be replaced. I replaced it with an OEM radiator, but there was a big difference. The new radiator didn't have an area to cool the transmission fluid. Thankfully, I already had a small transmission cooler, so I just routed it to that...
Hi,
As the title suggests, I am looking specifically for a working 2nd generation (69/03-72/09) temperature gauge. Ideally not too grungy and it must work please.
Thanks
Having issues with my ‘04 LC when trying to adjust temperatures. If I have it on AC and adjust the knob to warm or heat, I can hear “activity” under the dash but temperature stays cold. Last winter when I used the heater, it took it a while to engage and once it did it would just stay super...
If I want to check if my water temp gage is ready correct on my dash can I double check somehow? I have a direct temp laser could I shoot the engine block with that? What temp would you expect I should read after running engine
Dear Mudders,
there might won't be many FZJ100 owners on this forum, but i'm trying my luck anyway!
What readings do you normally get driving around in 20-30°C ambient temp. weather? the highest reading on the temp gauge I've ever seen is a tick below the mid mark (that was after 2hrs/200km...
How does this instrument panel work? It was imported to Brazil until 1967, then it was nationalized, I want to know how the temperature and fuel, ohmic range and power supply work
Trying to diagnose a few issues.
I have an ultragauge. Does anyone know which sensor it pulls its engine temperature from?
I thought it was the forward most sensor, but after replacing that sensor with a new OEM one, I have my doubts.
The engine temperature is actually about 186. It will...
I live in the Austin area and these 100+ degree days are taking a toll, not just on me but on my cruiser it seems.
Door actuators have zero problem in normal temps, but if the truck is left in direct sunlight on one of these days, they develop a mind of their own.
I’ve also noticed that the...
I was wondering if anyone else had the problem on the 100 series of the hvac either blowing super cold (turned all the way down) or super hot at anything other than the very lowest temperature setting. I don’t know what is causing it, or what to replace
I have a 97 80 Series with FZ-1FE engine. I've had it for 13 years and I reckon it has always run a bit hot. Lately it doesn't seem all that hard to get the needle in the top half of the gauge. Eg. cruising at 100kph on highway with or without a load but especially if in "heavy" sand even if...
I have been battling overheating.
I have replaced the thermostat. Water pump. Fan clutch. Belt. Radiator (new aluminum mishomoto). Temp sensor and temp sending sensor.
After this last round of maintenance in which the pump, fan clutch, and sensors were all replaced at once I took it for a...
Hi its been getting pretty out here in California recently and one thing I noticed is that all my gauges except for the Speedometer stops working and drops to zero once it gets above 100F. Has this happened to people? What do you guys recommend?
Gauge by ghong14 posted Sep 8, 2017 at 12:42 AM
The main temperature control knob on my lx470 the center console spins loosely when I turn it to adjust the temp. It does work to adjust the temperature but not accurately. Sometimes I have to spin the knob a few times and it'll just adjust by 1 or 2 degrees and other times it'll go to max...