rotor

Got the wrong rotors for my 80 Series due to bad information in the on-line Toyota parts catalogs... I've had them in storage for about a year. :bang: Brand new OEM. $120 shipped for the set. Would love to find a good home for them.

Pair of new in box OP Parts p/n 40551170 front rotors. Fit 60 and 62 series. $40 for the pair picked up in Upland CA.

Is anyone experiencing issues with front rotors? I have two GX, about 12-15 k after new brakes the vehicles experience a lot of vibration. I am told by dealer rotors re warped. Anyone experiencing similar issue?

2008-2013? Land cruiser 200 DBA rotor set. I've had for years and never used. I think it'll fit some early gen2 Tundras as well. Help me clean my garage. Retail is $800+. Asking $400. Located near Southern Pines, NC.

Hey all, my 03 Lc needs new front pads and I’m going to go with Toyota oem or advics but my question is does anyone know if any National places have the on vehicle rotor resurfacing capabilities. My rotors were put on new relatively recent and they bearings were repacked at same time so I’m not...

Hello- Got new tires 285/75/16 put on the LC last week. 4 days later wife reports grinding sound when braking coming from driver rear. Take off wheel and inspect. Indeed there is a grinding sound when turning the hub but also uneven wear on the pads. Outer pad is almost gone and inner has a...

Just had rotors turned on 2015 @ 30K.......no more vibration, but now pedal drops further. Assume result of less meat on the rotor? Did not change pads 8MM. Brake fluid reservoir about 3/4 full at rest. Any concern? THX

Some advice needed, Car cranks but no spark, took dizzy cap off and cranked but the rotor wasn’t spinning, took the distributor out and it spins freely out and the gears look undamged. When the distributor is in I can’t turn it by hand. Will take the valve cover off tomorrow but any...

Hey All, We did a couple of kinda 'how to' videos when replacing our brakes recently. I'm hoping they might help a fellow DIY driveway mechanic. Ben

After a recent steam cleaning, valve cover gasket replacement, throttle body cleanse, new plugs (NGK iridiums b/c I didn't plan ahead), new PCV w/ kit from Wit's End, fresh oil (switching to synthetic)...then 600 miles at 70 MPH mostly all good... Now I've hit a snag with the motor. Something's...

I need to check front brake rotor runout to see if one of them is warped too much. I don't have a dial gauge. My empirical mind tells me to take each rotor off in turn and put it on the stone kitchen benchtop which is measuribly 'flat' and check that way. Reason I want to do it is that when I...

I don't have a dial-gauge or really know how to use one, but I can think of two jobs straight off the top of my head that use one - setting timing for an injector pump on a diesel motor, and checking brake rotor run-out. Can someone give some advice on what kind of dial gauge to use for each of...

Doing what I consider a baseline+ maintenance which includes the valve cover gasket due to some massive oil leaks and noticed the front section of the cylinder head (where the timing chain and distributor gears are and thought they were rather dry. My question is, do oil galleries exist in the...

My FJ25 parts manual doesn't go back far enough. Anybody have the part number for the F120 cap and rotor? I haven't compared them to the F135 units yet so forgive me if they're the same. If not, I'm not holding up too much hope that they're still available. Are there aftermarket...

One new drilled rotor for an 80 series. I don't know why the previous owner kept this, but I certainly don't need it. $25 + shipping

everything flush, but no access to place ring clip?

Does anyone know of any caliper manufacturer that makes brand new, as in NOT remanufactured, calipers for an fj60 other than Toyota ?

I have started into the front axle rebuild job on my stock 1983 FJ60 (with 283 K miles) and had some questions I've come across. This isn't my daily driver so I want to do this right with no shortcuts and can wait for things to happen (new parts/tools etc) if needed. I have a Terrain tamer kit...

Thank you in advance for the insight! Here is my problem: brake pedal travel is really long on the first, and only first, depression of pedal. The second and subsequent presses, brake are amazing. Backstory: I took it to the shop and the front rotors machined and new front pads were installed...

Located in Houston, TX. You pay shipping. All of these parts were removed from my red 1985 first generation Toyota 4runner 4x4. Parting these out. Have a set of 4 wheels that I removed that you can find by searching my other ads. Parts are all in decent condition. Wear and tear on par for a...