hole

1" electrical knockout plug and an O ring does the trick. Bend the prongs out a little for a tight fit.

It is kind of like pulling a loose thread on a sweater... I noticed a pea-sized rock chip on the front hood. The chip had penetrated through the clear coat, finish paint through past the primer. No problem I thought. I'll just fill and touch it up I foolishly thought. The result was less...

Was parked in my apartment's parking garage but it's not secure whatsoever and located right off the street. Previously had a CAT cut halfway out before they got spotted and ran away, hopefully ya'll don't have my luck.

What should be bolted to this threaded hole (red arrow)? Passenger side near starter.

Can anyone tell me if this hole should be here? 1981 Need to know if I should reproduce this for the new bed? Thanks in advance

Anyone ever seen this?

It came out of the factory like this right?

My 83 had missing radio and wasn't able to find a plate as hole is different from earlier years. Found a guy on ETSY, Paulo from Portugal, who took my dimensions and fabricated one. Very reasonable price fits well, although I did need double face tape to secure properly.

I did a disc swap on my '73 FJ40 and I picked up a couple knuckle arms at a swap meet. It wasn't until I got the knuckle arms all cleaned up and painted that I noticed that they had different hole diameters for the tie rid ends. I guess there are different TRE's with large and small diameter...

1987, Carb ID 21100-61142. I am rebuilding this carb (my first time) since I bought the and wanted to tune it up. I have meticulously laid out each part in order of how I have taken it apart. Primary Venturi, then Secondary, in that order was how it was removed and laid out, and that is how I...

Looking for 2 early FJ40 door access covers with 4 holes like shown below, not the 6 hole version. Don't care about paint, but would rather not deal with dents. Thank you

Hi all, looking for any suggestions on how to patch a fist size hole on the drivers side rear quarter panel. From searching the forum it looks like a common place for rust. The mud flaps hide the hole so I’m okay with a simple functional solution. I also don’t have or know how to weld so...