Hey y'all,
curious what the recommended torque is for this EGR to intake gasket (see photo). I haven't been able to get this fella to seal properly and after two tries I'm clearly doing something wrong.
What's the torque spec and How many foot pounds at a time in sequence? What's the final...
Quick question for those in the know.
I'm going to install the CEL resistor mod for EGR. I don't want to remove the EGR parts just yet, but I do wanna turn that sucker off to prevent the carbon and heat issues that apparently effect cycl. 5 and 6. Anyway, what is the easiest and quickest thing...
Hey everyone
I just got done deleting the Egr on my 1997 hilux surf with the 3.0td and factory inter cooler. I used the blockoff kit from vanlife northwest and installed an egt temp probe on the exhaust plate. I cleaned a ton of carbon buildup out of the intake manifold and intake ports. I bled...
Is the EGR blanking plate the same for a 3L and 5L?
My 5L has an egr system that is full of carbon. I want to blank it off, but only really see blanking plates for 3Ls.
I still need to fully remove the system, but I provided photos below
Easiest for me is to by something than to create at the...
Been a minute since I've posted, but I've done alot of work recently to my Prado, heres the rundown-
AUDIO-
New front speakers 4"
New rear speakers 6.5"
Used sub box + amp
Did the whole shabang in a few hours, front speakers were pretty easy but the drivers had me pull the vent piece itself...
These all came off a running 1985 2F engine (FJ60) that thru a rod. I was going to rebuild the engine, but the block was cracked... Buyer pays shipping CONUS only:
EGR system -- Various, LMK what parts you want and we can work out a price
EGR vacuum pipes and all the rest — $100
EGR Cooler w/...
Looking to delete my EGR on my 1999 Prado 1KZTE. I’m at 250k km, want to hit at least 500k :)
I know this has been talked about lots, but no definitive instructions (that I can find) exist, and there are only one or two YouTube videos that don’t go into as much detail as I would like. I’ve also...
Good day guys....
Looking for some advice please.....How can i best do away with my EGR system. I have cleaned the system and tested all the vacuum lines and solenoids and everything seems to be okay...as soon as i press the accelerator a bit hard the damn glow light comes on and when i checked...
These two parts were pulled from a running 87 2F with 215k on the clock.
I dont know if they "work" so being sold AS-IS.
No idea on shipping. Will work with seller to achieve lowest cost.
Asking $250 OBO
Have other emission parts as well. Message me with particulars and I'll dig through the...
Hi all,
I’m getting close to putting my ‘77 CA spec FJ40 together and have to eventually smog the car. I’d like to understand what are the differences between EGR valves between the different years, or even within the same year. My questions are only about the EGR valve, not the cooler, pipe to...
Hey guys,
I've got an HD-FT non EGR. It has the stock exhaust system with the cannon end pipe. I couldn't stand it, so we cut it off and welded a 3 inch pipe on.
Not sure, but it feels I lost a bit of power/performance. Anyone got same experience or got the knowledge to enlighten me? Before...
First off, thank you, MUD community. I've searched through multiple threads for solutions to various problems, and because of the wealth of knowledge here on MUD, I have been able to find the answers I need to fix the issues I have encountered. I have never needed to post a question myself...
So I received bought a 95 4.5L and it had the typical mpg, this thing drank gas. Anyways I go to get it smogged and it passes everything but the egr test. Smog guy said it wasn’t holding vacuum, so I replace it and it failed again. He was a bro and passed it, but said to comeback when I fix it...
It seems like there are plenty of posts to diagnose most issues with the EGR system, but I think I’ve ran into a problem that’s not covered much.
I’m testing my EGR modulator. Looks brand new, clean filter inside, diaphragm holds vacuum when applying vacuum to the exhaust (bottom) nipple...
I took my 95 LC 4.5L to get smogged, it passed every thing, but the EGR valve wont hold a vacuum.
I replaced the valve and still it wont hold a vacuum, so I am getting a replacement.
Is he doing the test correctly? its in idle when he attempts. if i remember correctly my 88 4runner had a...
Hello all. Continuing in my 80 series resto-
Have codes 25, 26, and 71.
Running lean, running rich, and EGR System.
It’s worth noting the vehicle is running fine over all- no noticeable issues.
Any advice on where to start?