Anyone have pics of where they drilled and installed the snaps for their tiger top?
Also, I want to verify the "male" part of the snap size. it looks like they come in t 3/8 and 5/8" sizes.
The instructions show one place but my Tiger top snaps on my Jeep CJ8 were on the outer perimeter...
I have an old Tiger Top that came with the FJ that we are rebuilding. it has never been installed.
We were planning on installing it but we don't want to use the Screw-In button snaps that originally came with it. They now have a Threaded Stud option that has a nut on the back. See attached...
Wondering if anyone has ever put a hood latch underneath the hood of an FJ for added security
I don't know if anybody would ever try to unlatch both latches on the hood but it could be problematic if you don't realize it
Wondering if anyone has solved the problem with bikini tops and the bubble that happens when you're driving down the highway.
I have a full length bikini top to go with the full roll cage.
I was thinking about sewing in straps to attached to the middle section of the roll cage
I didn't know...
Got a 4 speed that easily pops out of 4th gear. This could be if you barely touch it with your hand or over a bouncy road with your foot off of the accelerator.
Any adjustments or fixes?
Have a Frankenstein FJ40. Body/frame is 1973. Engine, tranny, and t-case is 1978. Moved the gas tank to the rear and used a Chevy S-10.
Need an aftermarket sending unit that will register with the correct ohms on the Toyota gas gauge. We bought one of the boxes that we wired in that...
Got a 1973 FJ40, and thinking about changing the gears to get more highway friendly. I believe it has 4.10's in it and after '79 they moved to 3:73 gears for fuel efficiency. . It has a '78 Motor, 4spd transmission and t-case
Has anyone done this? What is the typical cost and who is the best...
We have a '73 FJ that runs really cold for the first 5 minutes. It has a 2F engine in it with a rebuilt Holley 2 Barrel carb. I have to start it and let it idle for about 5 minutes to get it to run right. It is almost like it is being starved of fuel. Once it is warmed up, everything is...
Last weekend we put in a new sending unit. The FJ cranked right up and and drove around no problem.
This weekend we were doing some more work on the suspension and we could not get it to crank. We are not getting any fuel from the fuel pump up to the carb. We pulled the air filter off the...
I was looking at different materials could be used as a floor mat for the tub.
I looked at the .5" horse stall mat.
Wondering what everyone else has used for this - if at all.
So we purchased the Boss Air Suspension from SloCruisers. We have a Chevy S-10 gas tank in the rear and going to have to reroute the exhaust location to install the air suspension.
It looks like the only location is going to be out the side in front of the passengers tire. See attached...
Got a '40 with 2 voltage regulators on it. one is for the amp meter, the other is hooked up to a warning light.
That does not sound right to me. why is there 2 of them