I just replaced my center accumulator with a newer one. In the process the tube from the pump to the center accumulator emptied it self. So now the accumulator is change and the canister filled with oil and i keep getting this code
C1762 - Abnormal oil pressure for pump.
Is this message related to the pressure switch on the pump housing? IT must, because each time i remove the connector and unscrew the sensor and put it back in. The truck AHC start operating normaly, something onyl one cycle (N to L and back) and sometimes 3-4 cycles. Until the off start blinking and it throw this same error again C1762.
My guess is that when i change the accumulator that pipe emptied itself and now it as alot of air and when i cycle the AHC air eventualy go back in pump and into the pressure sensor nozzle and keep getting this code.?
Right now the only good chance i have to restart the AHC is by removing this pressure sensor and putting it back. Then i might be able to raise it normally
C1762 - Abnormal oil pressure for pump.
Is this message related to the pressure switch on the pump housing? IT must, because each time i remove the connector and unscrew the sensor and put it back in. The truck AHC start operating normaly, something onyl one cycle (N to L and back) and sometimes 3-4 cycles. Until the off start blinking and it throw this same error again C1762.
My guess is that when i change the accumulator that pipe emptied itself and now it as alot of air and when i cycle the AHC air eventualy go back in pump and into the pressure sensor nozzle and keep getting this code.?
Right now the only good chance i have to restart the AHC is by removing this pressure sensor and putting it back. Then i might be able to raise it normally