ARCHIVE Wits’ End wasting time again but making ashtray less useless

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

is there room for proper laser etching...... :hmm:
 
Ashtray switch panels for the late model 80Series are all tested and in production. Needed to make one small change to one of the parts to make it perfecter ;)

6D86DD3A-6CBB-493B-AA50-6290DFEA3609.jpeg
ACC02F78-C15A-4620-B953-8EA9FF815100.jpeg
2D1AD1C5-87D3-4652-BF2A-E628CF3A5705.jpeg
 
We’re only 9 pages in thougho_O

Great point, this product should not be released until we thoroughly discussed it through at least page 100. Although I’ll be happy to be the beta tester and talk about it till page 101 when Joey is finally sure about releasing it to general public.....you are welcome.
 
Last edited:
Great point, this product should not be released until we thoroughly discussed it through at least page 100. Although I’ll be happy to be the beta tester and talk about it till page 101 when Joey is finally sure about releasing it to general public.....you are welcome.
Uhhhh...I'm not getting any younger over here. I'm OK with skipping over some of the discussion.
 
Joey, you have a milling machine in your shop? Are you making chips or are they going through a seperate machine shop? Inquiring minds want to know (aka, me, because I want an old clapped out bridgeport in my garage and I wanna know what you're running and how you like it)
 

Users who are viewing this thread

Back
Top Bottom