Window roller jumped out of the channel why? (6 Viewers)

[Dr Gil]

What would cause this green roller to jump out of the window roller channel? The symptom of this was that the window wouldn’t roll all the way up. Once I got into the door, I was able to put this roller back into the channel and the window work rolled all the way up.

I’m sure this will happen again if I don’t fix something. What is that something that caused this roller to jump out of the channel?

 

[rebelcruiser]

Quick WAG. Channel holding glass has slid on glass causing roller to extend beyond channel end. Fix: reposition glass in channel to position correctly so roller does not roll out at full extension.

 

[MissahPapaJ]

Is the grease supple ( not tacky / dirty ) in all grease zones, also clean the vertical tracks out. If that’s all good the regulator is possibly bent. Usually when I see that in any other cars shizz is all gummed up. Your stuff looks purdy clean but looks in photos on a tiny phone screen can be deciving.

 

[Kernal]

Already mentioned, something is bent, loose, broken, etc as the the green roller wheel should not come out of the track if everything is correct. Whatever the cause (glass/regulator loose/bent it) should become apparent once you get the door panel off, open the vapor barrier, and watch the regulator and glass move while pressing the up-down switch.