Where to get O2 sensor bung?

[sleeoffroad]

Glad to be of service I knew someone might need one or two.

 

[landtank]

what are they made of? Hoping SS.

 

[sleeoffroad]

They are not Stainless, however the studs and nuts are genuine Toyota parts. If we did stainless most people would have an issue with trying to weld them on. It is normally not the bung part that corrodes, but the studs. With a new gasket and some anti-corrosion put between the gasket and the O 2 sensor bung it should be good. As far as I could determine the factory ones were not stainless either.

 

[landtank]

yes, but when you're designing a SS down pipe it would be nice to have a SS bung.

 

[Lockd97]

Here is another option for future reference.

www.toyotacatalog.net/

 

[RavenTai]

does that one have a radius on the bottom? does not appear to be so.

 

[Lockd97]

The two I have do not. I plan to tackle that when i install them.

 

[martinakl]

$15 Solution from Bear River Converters in SLC

I know this thread is old but I found this and ordered one for a custom exhaust I'm planning.

It's from Bear River Converters in Salt Lake City. I almost ordered the one from Slee but when I found this for $15.00 delivered, I had to change my mind. Too simple of a part to pay $35.00 + Shipping. They accept PayPal for payment. I'll update once I actually do the exhaust system. Probably months away from doing it but gathering parts along the way.

Link takes you to an online catalog. Go to page 3 to see the part.

Untitled Page

 

[BruceFZJ80]

Any one have success with one of these options? I just replaced my cat and still have a leak at the o2 sensor and the studs are toast. My Y pipe is the original.

YotaShop
CruiserParts

 

[Fj80oregon]

Any one have success with one of these options? I just replaced my cat and still have a leak at the o2 sensor and the studs are toast. My Y pipe is the original.

YotaShop
CruiserParts

I have used the yota 1 set up a couple times and its great they ship super fast also.