I was removing my oil filter with the assistance of a removal strap and when I went back to install the new filter I saw this wire hanging. It appears that the plastic connector broke. Looking through the Electrical Wiring manual, it appears to be the crank shaft position sensor. Sounds important. The connector fit back together, but I am not sure it is going to hold.
Can anyone help?
(By the way, this is not a picture of my truck. I pulled the picture from this thread: https://forum.ih8mud.com/80-series-tech/294501-trick-removing-stubborn-oil-filter.html)
Can anyone help?
(By the way, this is not a picture of my truck. I pulled the picture from this thread: https://forum.ih8mud.com/80-series-tech/294501-trick-removing-stubborn-oil-filter.html)