I've been doing quite a bit of welding lately on the frame....mounts for the motor and tranny and such...anything that is horizontal or on a verticle plane is no problem
but anything that is upsidedown sucks....bottom of frame, bottom-side of any angles, etc....
Is there a good trick to not end up with chunks of weld spatter burning thru my shirt and leaving burn tracks down my chest/back??
Wire speed? Heat range? etc??
but anything that is upsidedown sucks....bottom of frame, bottom-side of any angles, etc....
Is there a good trick to not end up with chunks of weld spatter burning thru my shirt and leaving burn tracks down my chest/back??
Wire speed? Heat range? etc??