yeah, good point...the body of the ram gets mounted to the housing, the rod-portion to the tie rod....the body should stay stationary relative to the axle.
ways to weld directly to the 3rd member (1 Viewer)
- Thread starter camcruiser13
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #22
so it doesnt matter whow long or what the bracketery looks like as long as the it is strong and the ram is parallel then.
cuz im thinking my bracket might be 5 or so inches off the housing to get the ram parallel.
cuz im thinking my bracket might be 5 or so inches off the housing to get the ram parallel.
Last edited:
Think Spinal Tap.
I tried to limit the amount heat my third saw bc I figured I would melt an internal seal or something.
Like I said I will see if it breaks.
Like I said I will see if it breaks.
Not to get into the stronger, strong enough fight. But I would never weld to a 3rd just for the fact if I break on a trailride, or on a trip. Who is going to have a 3rd set up with the brackes welded to it? Remeber the time I blew my Rear in the Black Hills? I took my front out, and put it in the rear and went on a scenic ride for 1 more day.
- Thread starter
- #26
good point so i think ime going to go off the housing and fab up some bracket to make it work.
