Installed new starter.
Want to know if I can test it (bump it) before putting the top end back on?
If I pull the fuel pump fuse and just 'bump' the starter using the key in the ignition (to test the entire circuit) will it set off a bunch of 'codes' since a LOT of my wiring is not in place?
Please only experienced answers, no guessing...or "I don't think so, I think its OK, etc".
Thank you in advance.
Want to know if I can test it (bump it) before putting the top end back on?
If I pull the fuel pump fuse and just 'bump' the starter using the key in the ignition (to test the entire circuit) will it set off a bunch of 'codes' since a LOT of my wiring is not in place?
Please only experienced answers, no guessing...or "I don't think so, I think its OK, etc".
Thank you in advance.