Stuck Pilot Bearing - Tried Everything in FAQ (1 Viewer)

[Pin_Head]

You needed a half inch carriage bolt, but used a 1/4 inch. If you weld a bead on the outer race it will fall out when it cools.

 

[danrbrown]

Same has the bread trick except use grease and something that just fits the inner hole, hit it, then pack more grease in and try again these.

 

[Boaf 32]

Hydraulic Pressure. Right now, the end of the bearing came off, and I can see the balls. So I put my puller in again and but some pressure on it, and soaked the insides with WD40 and PB Rust. Leave it sit overnight, but not too confident.

Boaf

 

[mtquivr]

I had a SBC pilot bushing that wouldn't come out. I finally got it out using a grade 8 bolt. I found one that would just start into the bushing then ran it in with a 1/2" air wrench. As the bolt bottomed out, it pushed the bushing out.

 

[Boaf 32]

I had a SBC pilot bushing that wouldn't come out. I finally got it out using a grade 8 bolt. I found one that would just start into the bushing then ran it in with a 1/2" air wrench. As the bolt bottomed out, it pushed the bushing out.

Thanks mtguivr. Good and creative option!!!

Boaf

 

[Boaf 32]

Update: I had a 3 prong puller and used it as a semi slam hammer and vundeba'. It's out. ON to the next challenge.

Boaf