Builds starting my frame off

[effjay76]

I've been off-roading the truck and driving it to work. Taken it on a trip to Austin and a trip to McAllen. Did wel on the highway and was a blast on the trails. The carburetor struggles on the steep inclines but other than that, works great. About to take the top and doors off again and do weatherstripping/ Windows. Here are some pictures from the off-roading trips

 

[effjay76]

Well I have done a lot since my last post. I painted the truck again, this time with real paint (ppg epoxy primer and single stage enamel) I have also completed the mechanical portion of the 1uz swap. I will dump lots of pictures and try to keep in chronological order. I also bought an fj60 and have done lots of work, I’ll create a separate thread on that.

 

[effjay76]

More paint prep/rust repair.

 

[effjay76]

Restoring the top with the ccot sill rebuild kit. Por 15 on all the metal

 

[effjay76]

Top cont...

 

[effjay76]

I painted the sides and doors, installed weatherstripping and windows, then decided to take the truck to big bend for some off-roading and camping. Went great. The 40 performed flawlessly.

 

[effjay76]

Took a break to paint my friend’s 69. He wanted medium blue so that’s what we did.

 

[effjay76]

Back to my 40! Headliner and 1uz valve covers.

 

[effjay76]

Tub prep, missing photos of the finished tub so I’ll post next if I can find them.

 

[effjay76]

Some 3d printing projects I’ve been working on, first is a removable wire grommet for the firewall. I’ve made multiple sizes for 40 and 60. Very nice solution. Second is some custom gauge bezels I was playing with for auto meter gauges.

 

[effjay76]

Time for the 1uz swap. I’m using the original 4 speed transmission and t-case. Custom adapter plate to the 1uz bellhousing, using sbc adapter plate that I originally had.

 

[effjay76]

The other parts used are :
custom flywheel
Mr2 turbo pressure plate
Jeep cj5 clutch (matches input shaft gear)
Sourced correct crank bearing for input shaft
Hydraulic throw out bearing kit from summit

 

[effjay76]

Installing, repositioned motor mount perches on frame.

 

[effjay76]

I had the original seats reupholstwred as well as a set from a matrix that are much more comfortable. And some pics for fun.

 

[effjay76]

Finished up the steering system fab over the thanksgiving holiday, made mounting plates and brackets etc. Also cleaned up the hole in the crossmember from previous Saginaw install before I had the truck.

 

[effjay76]

Finished hole

 

[effjay76]

I needed to notch the radiator support a bit to clear the steering shaft and clean up the butchery that had been done before.

 

[rickpaw]

Nice work on the FJ

 

[effjay76]

Welded the spacers onto the steering box mount and por 15’d the whole setup

 

[rickpaw]

Nice work. Where about in Houston are you?