Source for 4.3:1 gearset?? (1 Viewer)

[mudgudgeon]

Hi y'all

I'm looking for a set of 4.3:1 diff gears to sit FZJ80 rear diff.
So far no dice.

Anyone know of a source for quality gearsets in this ratio?

I have an OEM e-locked front diff centre that I had built with 4.3:1 gears and solid surface for a 105 series that I'd like to use in my 80, I also have an OEM e-locked rear diff centre that needs a rebuild and re-gear.
A little lower gearing would be nice, but I'd prefer to buy one gearset than two.

 

[Trail Mule]

I personally have never seen 4:30 gears. I know there are 4:56, 4:88, 5:29

 

[Cruzilla]

Got 4:30 gears in my tundra..

 

[White Stripe]

Some 100 series and 200 series were 4.3 from the factory. You would have to use the whole carrier though I believe from one of those and swap out the side gears.

 

[mudgudgeon]

4.3:1 gears were standard in 105 series cruisers. Unfortunately the crown and pinion aren't interchangeable from 105 to 80 series rear diff

 

[mudgudgeon]

Some 100 series and 200 series were 4.3 from the factory. You would have to use the whole carrier though I believe from one of those and swap out the side gears.

yep, doesn't help me use the locked centre I have

 

[White Stripe]

yep, doesn't help me use the locked centre I have

Did you check Mark's 4wd? They have probably the most ratios. If they dont have it then its probably not available

 

[mudgudgeon]

Did you check Mark's 4wd? They have probably the most ratios. If they dont have it then its probably not available

Didn't think of Marks. Sent then an enquiry

 

[mudgudgeon]

Didn't think of Marks. Sent then an enquiry

No joy there

 

[junior80]

Tried jmac diff and gear?

 

[davegonz]

Partsouq?

 

[mudgudgeon]

Not yet

Tried jmac diff and gear?

Not yet. Was thinking they're a good option to do the rebuild though

 

[mudgudgeon]

Partsouq?

Hmmmm, not sure if there was a factory 4.3:1 gearset for the 80 series centre

@Onur do you know if there was a factory option?

 

[I Lean]

Hit up @cruiseroutfit and see if there are any options--but to my knowledge, the 100 series is when the 4.30's came in a 9.5" diff....which will use a different carrier than your 80 series E-locker.

4.30 take-out gears are easy to come by for 100's, if there is some way to make them work....I have a set on my shelf right now, as a matter of fact.