sm420 swap options for front driveshaft flange (1 Viewer)

RAYJON

Get a bigger hammer..
Joined
Oct 20, 2005
Messages
1,863
Location
Reno NV
does anyone have other options for the front driveshaft flange and shaft, having a hard time finding a pre 68 shaft and flange...
 
Joined
Feb 6, 2002
Messages
15,226
Location
OC, CA
It depends on what adaptor you use, but I presume that you are using a plate adaptor because you need a smaller 3 speed drive shaft flange/slip yoke to clear the tranny hump with a plate adaptor. You just have to keep looking until you find one. You can use a 4speed front shaft if you move the axle forward by one inch by drilling new holes in the spring pads.
 

RAYJON

Get a bigger hammer..
Joined
Oct 20, 2005
Messages
1,863
Location
Reno NV
Got your pm steve will call you tomorrow, its wardens plate, and the axle is already moved figured on modified shafts anyway,

I can machine something if I have to just wondered if someone made a new flange I could trim down...
 

Users who are viewing this thread

Top Bottom