i'm goin sbc,sm465,np205 in the 60 next spring or asap
but i needed to offset the axle on the drivers side.( thats how the 14 bolt was on the donor truck i pulled the engine and trans)
picked up a complete axle from todd in fort collins (thanx)
i've got the backing plates and brake componets off to swap them from side to side. i should be able to retain my e-brake by doing this.
do a little brake line fenagling, cut some notches in the housing so the ring gear can rotate. weld on some new perches and wrap bar brackets and i'm good to go.
just gotta get workin on the motor.....
but i needed to offset the axle on the drivers side.( thats how the 14 bolt was on the donor truck i pulled the engine and trans)
picked up a complete axle from todd in fort collins (thanx)
i've got the backing plates and brake componets off to swap them from side to side. i should be able to retain my e-brake by doing this.
do a little brake line fenagling, cut some notches in the housing so the ring gear can rotate. weld on some new perches and wrap bar brackets and i'm good to go.
just gotta get workin on the motor.....