I just finished putting a torsen lsd in the front of my 62, the hitch is that it came in a course spline third out of a '77 40. I now have to figure out how to make it work with my 62 driveshaft. My thoughts are:
-call kurt and see if he sells course spline flanges with a 62 pattern (who else sells course spline flanges)
-center the 62 shaft over the flange on the third, drill the new pattern, then turn the holes into slots. I figure that since the ring on the driveshaft seats into the pinion flange that as long as i can keep the bolts tight as far as side to side play then it should be fine.
-swap a 40 slip yoke into my 62 driveshaft
So, what are your opinions. Im looking for as cheap as possible without being too afro-engineered.
-Matt
-call kurt and see if he sells course spline flanges with a 62 pattern (who else sells course spline flanges)
-center the 62 shaft over the flange on the third, drill the new pattern, then turn the holes into slots. I figure that since the ring on the driveshaft seats into the pinion flange that as long as i can keep the bolts tight as far as side to side play then it should be fine.
-swap a 40 slip yoke into my 62 driveshaft
So, what are your opinions. Im looking for as cheap as possible without being too afro-engineered.
-Matt