Panhard torque spec ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 5, 2006
Threads
388
Messages
1,210
Well after rebalancing the tires. Retorquing the wheel bearings. I found the cause of my death wobble.

Turns out I could turn the upper nut on the panhard rod by hand !!!! (Thought I checked the obvious stuff first !)

Does somebody have the torque spec for the panhard bolts handy ?
 
Front or back?
Back is 130 at frame and 181 at axle end.

Edit:
Front is 127 at axle and frame end

check to make sure the bracket did not get ovalled aka wallered out
 
AKA: German-spec "guttentight"
 
Thanks @jfz80
I found this thread from @Tools R Us , after I posted the question


I’ll see if my little 3/8 drive torque wrench even goes up to 127 !!
 
How do one even get to 181???

With one of these:
IMG_0937.jpg
 
Ah yes, the ol' white knuckle slammer
no, an ugga dugga is a unit of measure for squeezes from an impact gun:

 
no, an ugga dugga is a unit of measure for squeezes from an impact gun:

"To count an Ugga Dugga one must be wearing a ball cap backwards, have at least one busted knuckle, a beer in reach. Then as you squeeze the trigger of your impact gun, you count off like so, "One Ugga Dugga, Two Ugga Dugga, Three Ugga Dugga..etc" Don't forget the southern, redneck drawl or to spit the juice from your oral tobacco products, or else your Ugga Duggas will not be sufficient."

wtf are you making me read
 

Users who are viewing this thread

Back
Top Bottom