Oil temp sender connector ... terminal end (1 Viewer)

Joined
May 31, 2019
Messages
15
Location
Montana
So was hoping someone could help me, the wire going into the connector to the oil pressure sender came out of the terminal end which is insider the plastic connector, Below are some pics, so I would like to get the terminal end out of the plastic connector so I can do a good job of reattaching the wire, but don't want to break the plastic trying to get it out. Is there a simple way of getting the terminal end extracted? Thanks for anyone's time to help.

IMG_3015.jpg
IMG_3012.jpg
IMG_3018.jpg
IMG_3019.jpg
 

Users who are viewing this thread

Top Bottom