||| Official YT For Sale/Trade/Wanted Thread ||| (4 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

74FJ40, 305 SBC, rebuilt SM420/3 speed Toy T-case. 4 wheel disc brakes. 60 series steering box, 4x4 labs high steer arms and heavy duty tie rods, Chevy 1 ton tre's. Longfields, Lockrites front and rear. Shackle reversal, spring-over on the front axle. RuffStuff brackets. 4" lift springs on the rear. (comes with a stock set of rear springs) Warn 9000 with synthetic line. Tub was rebuilt when I bought it. Not rusted out, but plenty of dents. Fuel tank is an OE steel tank that is less than 10 years old. $5600

View attachment 1672844
Come on, find someone to buy this thing!
 
ARB full length roof rack for sale. Has rain gutter mounts and will bolt right up to 60 or 80 series. Has some scratches and a little surface rust on bottom side. $600


E4761519-A12F-4062-9924-8934F82B56CC.jpeg
E859B300-1C75-4205-A17D-EF5A4F131470.jpeg
0FDA89A0-F17C-43B5-8EDD-88160AB8F243.jpeg
4191D519-5AF2-4D9E-A7CF-924C932D64B0.jpeg
 
A friend of mine is selling his 2011 Tacoma. Contact his wife, Marly, marlyashworth@gmail.com, for questions, etc. Located in Windsor, VT area.


2011 Tacoma access cab
Standard transmission
4 cylinder
97k Miles
Very clean inside and out
Drives perfectly
Has had all service done at dealership
Has been garaged everyday and has had seat covers on all seats
Comes with very nice tires and tonneau cover
Asking 15k obro
4wheel drive

IMG_3353.jpg
IMG_3348.jpg
IMG_3354.jpg
IMG_3347.jpg
IMG_3351.jpg
 
Anyone know where to get a starter for my 1982 BJ42 LX? 12 volt , 11 teeth, 2.5w?
Mine is acting up...
Went to rebuild it and found it was already swapped with an aftermarket that I can't find parts for. Cleaned it up and replaced one contact, and so far so good. But would like to have a spare in case it acts up again.


Part number ? 28100-56080

Matt
 
Anyone know where to get a starter for my 1982 BJ42 LX? 12 volt , 11 teeth, 2.5w?
Mine is acting up...
Went to rebuild it and found it was already swapped with an aftermarket that I can't find parts for. Cleaned it up and replaced one contact, and so far so good. But would like to have a spare in case it acts up again.


Part number ? 28100-56080

Matt

Buy an early 80’s diesel pickup truck starter (2.4l?) from rockauto for like $100 and swap the 3B nose cone onto it. Works like a charm.
 
The nosecone swap is a option, but I don't think the starter motor is the issue, it was the solenoid, maybe if I take the solenoid apart again, measure the components and get a full rebuild kit, that may do it... maybe a winter project.

I was hoping to find a real NipponDenso that would fit, that I could rebuild and have a spare.

Thought 40Flipper might know of a source as I bought the truck from him, and he has had a few of these diesels. I will have to PM or text him.

Did finally find a shop that might be able to rebuild it if I am unable.
 
The nosecone swap is a option, but I don't think the starter motor is the issue, it was the solenoid, maybe if I take the solenoid apart again, measure the components and get a full rebuild kit, that may do it... maybe a winter project.

I was hoping to find a real NipponDenso that would fit, that I could rebuild and have a spare.

Thought 40Flipper might know of a source as I bought the truck from him, and he has had a few of these diesels. I will have to PM or text him.

Did finally find a shop that might be able to rebuild it if I am unable.


You can still use all the new solenoid parts. You’d be amazed what a new starter can do for a 3B. Sometimes you don’t realize how weak the motor is until you get a new one in there. I’ve also seen bad 3B starter motors show similar symptoms to a bad solenoid.
 
I'd like to sell the original passenger side doors and the lower tailgate from the 60 in my profile pic. These pieces do have rust (shown in craigslist post below), but the skins, windows, etc. are good. Can deliver to local members of YT / IH8Mud. All offers considered, I just hope someone can make good use of them.

https://boston.craigslist.org/gbs/pts/d/fjlandcruiser-doors-and-rear/6613175287.html

Cheers,
FJ60Boston
 
Thought 40Flipper might know of a source as I bought the truck from him, and he has had a few of these diesels. I will have to PM or text him.

I only appear to know what i'm doing.
 
I'd like to sell the original passenger side doors and the lower tailgate from the 60 in my profile pic. These pieces do have rust (shown in craigslist post below), but the skins, windows, etc. are good. Can deliver to local members of YT / IH8Mud. All offers considered, I just hope someone can make good use of them.have any fj60 headlight trim driver and passenger side ?

https://boston.craigslist.org/gbs/pts/d/fjlandcruiser-doors-and-rear/6613175287.html

Cheers,
FJ60Boston
Any fj60 headlight trim
 
36x12.5x17 Irok Super swamper
Used swamper mounted on a New pro comp Toyota wheel 6 lug on 5.5 pattern 4.5” back spacing. Good for spare
$50 in Long Island NY
I have a local friend who’s constantly going to the north east area to wheel if anyone interested

A331F160-E9A3-4788-AE62-55EDF869291B.jpeg


4D297A9C-E715-4DB1-8E5B-48C02E69EDFF.jpeg


9A951C72-2CB5-4B93-A6CB-73FB284CA2A4.jpeg
 

Users who are viewing this thread

Back
Top Bottom