non skid step

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Anyone have any short boards in good condition they want to trade for a great set of long ones? My cruiser is set up for short boards. I dont want to drill if I dont have too.:)
 
Tread stuff Looks Great. I just need to put it on :)

Thanks Fox and Nerd :)
 
I believe Dave fjfjfj found a source for his 62 FJ40. Might check with him. I believe he had some he didn't like a found better material and sold the other stuff. Check with him and report back.
 
My mat is only 3' X 3', I thought I had 6' of it.

Good news is I can still cover John and Ken.

I'll get them cut up for you guys



image-3682078071.webp



image-1929229122.webp


If I remember correctly, the place I purchased the matting from was East Coast somewhere? I could probably dig the name up if needed?

image-3682078071.webp


image-1929229122.webp
 
67azcruizr said:
My mat is only 3' X 3', I thought I had 6' of it.

Good news is I can still cover John and Ken.

I'll get them cut up for you guys



View attachment 834085



View attachment 834086


If I remember correctly, the place I purchased the matting from was East Coast somewhere? I could probably dig the name up if needed?
Click to expand...

Did you get the matting from canal rubber.com, if not where did you get it from? thanks
 
Interesting to know if there is some brand or type on it. I am also in need, but it would be best if I can find it locally.
 
Just remember if you're dealing with perfectionists, the side of the square pattern is parallel to the outside of the board (ie. they need to be cut at a 45* angle out of the material) which wastes a hell of a lot. At least that's what I remember from way back.
 
You must log in or register to reply here.

Users who are viewing this thread

Total: 1 (members: 0, guests: 1)

Share this page

Back
Top Bottom