non skid step

red66toy · Jan 28, 2006

Anyone have any short boards in good condition they want to trade for a great set of long ones? My cruiser is set up for short boards. I dont want to drill if I dont have too.

wesintl · Feb 27, 2006

Tread stuff Looks Great. I just need to put it on

Thanks Fox and Nerd

pardion · Nov 23, 2013

Did anyone end up with an extra set? Old fart needs a set for small running boards. Thank's, John

Living in the Past · Nov 23, 2013

I believe Dave fjfjfj found a source for his 62 FJ40. Might check with him. I believe he had some he didn't like a found better material and sold the other stuff. Check with him and report back.

67azcruizr · Nov 24, 2013

I have you covered John, I have a whole roll of the stuff

pardion · Nov 24, 2013

67azcruizr said:
I have you covered John, I have a whole roll of the stuff

Sean saves the day again! Thank's John P#3

eltioloco · Nov 24, 2013

Hi Sean, I would like to buy enough to do my 62 FJ. If you can spare a square.
Thanks, Ken

cruiserloser · Nov 24, 2013

eltioloco said:
Hi Sean, I would like to buy enough to do my 62 FJ. If you can spare a square.
Thanks, Ken

Ken - I have a bunch of this too. If Sean is out, take a measurement and let me know roughly how much you need.

Dave.

67azcruizr · Nov 24, 2013

My mat is only 3' X 3', I thought I had 6' of it.

Good news is I can still cover John and Ken.

I'll get them cut up for you guys

If I remember correctly, the place I purchased the matting from was East Coast somewhere? I could probably dig the name up if needed?

tahoe40/45 · Nov 24, 2013

67azcruizr said:
My mat is only 3' X 3', I thought I had 6' of it.

Good news is I can still cover John and Ken.

I'll get them cut up for you guys

View attachment 834085

View attachment 834086

If I remember correctly, the place I purchased the matting from was East Coast somewhere? I could probably dig the name up if needed?

Did you get the matting from canal rubber.com, if not where did you get it from? thanks

hdjtachtig · Nov 24, 2013

Interesting to know if there is some brand or type on it. I am also in need, but it would be best if I can find it locally.

67azcruizr · Nov 24, 2013

tahoe40/45 said:
Did you get the matting from canal rubber.com

that's it

http://www.canalrubber.com/pyramid-vinyl-matting.html

eltioloco · Nov 25, 2013

67azcruizr said:
My mat is only 3' X 3', I thought I had 6' of it.

Good news is I can still cover John and Ken.

I'll get them cut up for you guys

Thanks Sean.

Cruiser_Nerd · Nov 25, 2013

Just remember if you're dealing with perfectionists, the side of the square pattern is parallel to the outside of the board (ie. they need to be cut at a 45* angle out of the material) which wastes a hell of a lot. At least that's what I remember from way back.