I've recently replaced the coolant temp sensor, which unleashed a gushing coolant beast and soaked most of the driver side engine. I poured probably about a gallon of water in that general area to flush out the coolant before it dries. The water was poured in that general area:
I was careful to avoid alternator or any major electrical connections, however after that my truck wouldn't start (no spark I suspect) until it dried off.
Question: What might have caused it? I ordered a new coil pack because that's the only thing I though that could have gotten wet. I want to "bullet-proof" whatever caused this in that area as I don't want to worry about that area getting wet from anything in the future. Any ideas?
I was careful to avoid alternator or any major electrical connections, however after that my truck wouldn't start (no spark I suspect) until it dried off.
Question: What might have caused it? I ordered a new coil pack because that's the only thing I though that could have gotten wet. I want to "bullet-proof" whatever caused this in that area as I don't want to worry about that area getting wet from anything in the future. Any ideas?