New to IH8MUD and New to FJ60

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

image.jpg
image.jpg
image.jpg
image.jpg
image.jpg
 
Gear lever at reverse and still has some good clearance between console n lever, hand brake lever relocated to right hand side of the driver seat. So when I'm on long trips will remove middle row seat and use some cushion to fill up the gap in leg space of second row. So I can make use of 3 rd row seats while travel which can be folded upwards if wanted a large party space, hope you guys like it.
image.jpg
image.jpg
image.jpg
image.jpg
 
For the interiors a complete rolled out Mitshubushi Pajero was bought and stationed beside for easy acess. For color have decide with red shade similar. image.jpg
 
did power window for all 4 doors came out well used Suzuki swift power window complete setup here is a short video on it
 
image.jpg

image.jpg

image.jpg


Inner fender trimming to accommodate AC compressor alternator and intercooler plumping done, all 4 door power window operations done
 
You've just got no respect for any kind of convention or construction road block hey.
Bravo, every time I see you post I think what has this crazy bastard done now and every time you don't let us down.
You're a tribute to your country.
 
Please post a picture of the relocation of the emergency lever so I can copy it! ;)
 
Cruiser pilot did u mean hand brake lever? WIP so the picture not so clear.
image.jpg
image.jpg
 
Genius, thanks. I want to relocate my emergency lever so I can put in a wider console. I had not
thought of this. J
 
Cruiser pilot bro all of your words means a lot to me if not I would not have come up all the way in my build. Actually I had only 2 choice either I relocate my hand brake lever are loose it, as the center console is a must as when I bought it 2 years back it occupied 1 complete luggage out of 2 so I wouldint want to let it go.
 
Almost 2 months lot of things has been done, preparation for painting in progress also started of with dash board installation, windshield demister also completed and started of with front and rear bumpers with PTO winch installation.
image.jpg
image.jpg
image.jpg
image.jpg
image.jpg
Used chassis of mini truck for front section and 16 gauge sheet metal to cover up, due to PTO winch front bumper is almost 16" overhang in front of vehicle.
 
Not sure you guys like the final outcome of front bumper but frankly speaking after all my effort this is what I managed to get
image.jpg
image.jpg
image.jpg
image.jpg
image.jpg
 
Last edited:
image.jpg
image.jpg
Looking to install 2" gauges volt, boost and temperature not yet decided on location just got 2 ideas which one friends? Need suggestions

image.jpg
 
image.jpg
Managed to source n install D-shackle heavy duty ones for recovery options, another side swing out also done.
 

Users who are viewing this thread

Back
Top Bottom