Hey everyone,
Just got done my disc conversion using FJ60 knuckles on the front and Poser's kit in the rear. However, my new, NAPA rebuilt brake master cylinder (also 60-series) started leaking from the front "reservoir" (where the hose connects, under the rubber cap). There is a snap ring holding the tube in, and I believe an o-ring under the tube. I'm guessing this oring isn't seated properly?
My question is, before I dig in, does anyone know how it SHOULD be seated? Any other potential causes of this?
If I have to bleed the whole system again, I'd rather only do it once.... Thanks!
Just got done my disc conversion using FJ60 knuckles on the front and Poser's kit in the rear. However, my new, NAPA rebuilt brake master cylinder (also 60-series) started leaking from the front "reservoir" (where the hose connects, under the rubber cap). There is a snap ring holding the tube in, and I believe an o-ring under the tube. I'm guessing this oring isn't seated properly?
My question is, before I dig in, does anyone know how it SHOULD be seated? Any other potential causes of this?
If I have to bleed the whole system again, I'd rather only do it once.... Thanks!