mounting question for 12ht/2h into a 40. (1 Viewer)

[Will Van]

My HJ47 bellhousing and clutch fork came in today from Australia. The bellhousing does not have the "HJ" casting on the top, so I think it is correct.

I'm going to powdercoat everything. Any suggestions for this clip? I'd prefer not to remove it. Maybe they can just powdercoat it as is? It's going to get worn as the clutch fork pivots anyway.

 

[Will Van]

@roma042987, I also took your advice and reached out to @lcwizard about the H55F skid plate. My fabricator thinks it won't be a problem with the parking brake drum and speedo cable.

 

[Will Van]

Another question - I have the HJ47 aluminum bellhousing. I need the braces that reinforce the bellhousing at the sides of the 2H/12HT.

Can I use the braces from an HJ75 or HJ60? Or are the bellhousing braces HJ47 specific?

Edit: I did more research and the part numbers are the same: 33118-60010 for RH and 33119-60010 for LH for both HJ47 and HJ6#. I suppose we'll find out for sure when I go to install.

 

[roma042987]

Cool pictures....they look familiar

 

[Will Van]

Cool pictures....they look familiar

Thx! I blatantly stole them from...someone. ‘Can’t remember who.