Is this an expensive part from Toyota?

[Micah]

Every time time I go to put on a new replacement part it seems like I find more problems.

is this an expensive part from Toyota?

 

[AATLAS1X]

IIRC it was $100 for mine. I had a lope at idle it was due to a crack on the back side that was not visable. If it is cracked, replace it.

Shane

 

[REKCUT]

Use one of the two toyota venders here in the mud vender section. Cruiser Dan or Toyota of Dallas. Both give around 25% discount on toyota products to members

 

[cruiser88]

thirty some bucks and you are set.....i built my own














It end up costing about the same in the end.

 

[inkpot]

Howdy! I'd throw some duct tape over it temporarily to see if it runs better w/o the air leak. Then you can take your time finding a used/new replacement. John

 

[GLTHFJ60]

I'd say make your own. Go down to a in ground pool merchant and pick up some translucent sliicon tube of the correct size, slip it on and tighten it up, then you're all set.

 

[dixie_cragger]

i ended up replacing mine for $35 bucks from cruiserparts.net. If i were to do it all over again, i would go ahead and buy a new OEM from Cdan and never worry about replacing it again!

 

[Micah]

Use one of the two toyota venders here in the mud vender section. Cruiser Dan or Toyota of Dallas. Both give around 25% discount on toyota products to members

Thanks guys, that price makes me happy. I was afraid I was going to have to drop $150 or something like that.

Um CDan is out until Saturday, who is the contact at Toyota of Dallas?

 

[pappy]

$81.54 list.

 

[bkfj40]

I'd put some west virgina chrome on there (i.e. duct tape as previously mentioned)


bk

 

[cruiser88]

I'd put some west virgina chrome on there (i.e. duct tape as previously mentioned)


bk

ya ......