Installing a Chevy 350

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Nvrlose54,

Do you have any up close pictures of your motor mounts, so he can get an idea what they should look like installed.

Man, that makes all sense in the world, sneaky.
I’m going with nvrlose54’s advice. It will be the most straight forward. I removed the bellhousing mounts from the frame this afternoon. I’m going to weld them to plates so that I can get them put on the frame nice and clean. Welder is out of gas, so she’s parked until tomorrow!

I’ll have to take some pics. I went the simple route, 1/4”x 2.5” x 2.5”angle iron then gusset both sides. 2.5” angle allows plenty of room for the mount mount/ bushings to fit.
 

Users who are viewing this thread

Back
Top Bottom