I’m not sure.
But the zxr is one of the smallest 12,000 lb winches so if any will fit, it’ll likely be that one.
Install notes for Ironman bullbar on a 2008 LX (3 Viewers)
- Thread starter tbisaacs
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
But the zxr is one of the smallest 12,000 lb winches so if any will fit, it’ll likely be that one.
I don’t know if I’ve already posted these photos somewhere but I’ve been asked for them a couple times via social media…so I’m going to post them in this thread.
(5 photo limit)
Last edited:
- Thread starter
- #45
Just notch the iron man brackets and run whatever you want.
Builds - Travis’s PNW LX570
The last thing in my quest for ∞ fridge usage was to install an onboard lithium Noco 5amp smart charger and an external outlet. After talking to @radman and re-reading @BloggerL's build, I decide to cut a scary hole in my rear fender and pass it through the jack compartment: And in case you...
forum.ih8mud.com
Like tbisaacs said, you can notch the mounting brackets for the ironman and run arb recovery points…images attached.
- Thread starter
- #48
1 is ground
1 in turn signal
1 is drl
1 is parking
I used a scotch lock connector to t-into headlights etc
Are the colors of the wire mach colors on the headlamp wires? How to identify them?
- Thread starter
- #50
No they won’t. You can find the wires on the headlights by looking at the connection going into bulbs. For DRLs you can use Any switched 12v source.
Do you have a picture of how these mounted? Did you still need to notch the iron man bullbar?
Lastly, what did you end up doing with your front facing camera?
- Thread starter
- #52
I ended up not using them. They eat up like 4” front clearance because they hang so low. I notched the iron man mount and am running arb recovery points.
Camera is mounted in the slot just above winch fairlead. Yes I took a hole saw to my front plate
With the same trimming could you have kept the stock ones?I ended up not using them. They eat up like 4” front clearance because they hang so low. I notched the iron man mount and am running arb recovery points.
Camera is mounted in the slot just above winch fairlead. Yes I took a hole saw to my front plate
View attachment 3725401
- Thread starter
- #54
Yes but those aren’t rated for recovery.
What made you change your mind?
Last edited:
- Thread starter
- #56
your link doesnt work—but lots of smarter people than me who do harder recoveries than I have. I'm not here to change your mind either way.
Updated the link, thanks. Was just curious what your deciding factor was to move away from them. My use case is more moderate than hard-core. Level 3 (out of 5) trails max.
