DocuDude
Took me 10 years to find this space
So the PHH was an alright job. Easy enough (snap the bottom tab, no bypass)
But I didn't remove the knock sensor, so that broke.
And now as I tried to remove the broken knock sensor from the male connector, the wire ripped off the back.
I can take a pic of the electrical wire if needed, but its a clean break right at the tip. All the twisting, trying to remove the K/S finally caused the wire to snap.
So now I have a still stuck broken knock sensor inside the female that needs to be reconnected to the wire.
What is the best way to reattach the male connector to the main wire?
But I didn't remove the knock sensor, so that broke.
And now as I tried to remove the broken knock sensor from the male connector, the wire ripped off the back.
I can take a pic of the electrical wire if needed, but its a clean break right at the tip. All the twisting, trying to remove the K/S finally caused the wire to snap.
So now I have a still stuck broken knock sensor inside the female that needs to be reconnected to the wire.
What is the best way to reattach the male connector to the main wire?