I took the carb and manifolds off my 76 fj40, cleaned everything, new gaskets etc. Now it stalls when idling. It runs fine when I give it gas. Could I have some sort of vacuum leak? I see gas in the carb sight glass and all the emissions are hooked back up correctly. Any suggestions? It worked fine before I did anything.
Help..I'm stalling out
- Thread starter makomark
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
so it runs good with gas? Maybe just need to adjust idle screw. Can you keep it running with leaving the choke knob out a little?
- Thread starter
- #3
I will try and see if it will run with the choke open...thx
And have you retorqued the manifolds until the torque does not change?
leak
Seems like you could have a vacuum leak Id try loosening the bolts and wiggle fit it again and re-torque---but check the carb base before you do JIC
Also recheck your vacuum line connections
Seems like you could have a vacuum leak Id try loosening the bolts and wiggle fit it again and re-torque---but check the carb base before you do JIC
Also recheck your vacuum line connections
- Joined
- Apr 14, 2004
- Threads
- 1,466
- Messages
- 36,634
- Location
- 818-953-9230
- Website
- www.marksoffroad.net
Did you reconnect the wire for the fuel cut solenoid?
- Thread starter
- #7
It will run with the choke open a little bit and dies when the choke is closed. I have re-tightened all the bolts on the manifolds and carb. It still stalls out. I'm not sure what to try next...
- Thread starter
- #8
Update. It will idle when I disconnect the rubber line from the intake manifold to the emissions computer and put my finger over the port on the intake manifold where the rubber line was connected. does anyone have any ideas?
JohnnyC
Long ago TLCA# 2231
sounds like you found the problem...does that line have a crack in it?
- Thread starter
- #10
I don't see any cracks in it, should I be getting a suction pull from these hoses?
