I didn't have any problem with any alarms. After replacing the motor and bench testing and working I reinstalled into LC. Didn't work. I tested wire harness between actuator and the connection point by my left foot behind the panel. Found 2 broken wires, one for the lock one way and the other was the limit switch. If you needed to do this you can unplug the harness from inside the vehicle then loosen the rubber boot between the door and cab and pull into door. before I did this I did check the continuity between the color coded wires and it showed 2 bad. I used butt splices to reconnect. Hope this can help
Richard
Richard