Thanks. You’re not running a body lift like he will be though, are you?
Dissent Front/Rear Bumper install instructions (LX) (2 Viewers)
- Thread starter radman
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Not yet;
I plan to have spring rubbers for front and 20mm spacers for rear to augment load. Probably will add front spacers when I do AHC service. Sensor lift is on the cards too
teejnut
SILVER Star
I've reach out to Dissent already, but anyone have issues with the tire carrier lug pattern not lining up?
With a stock wheel and lug nuts I can get 2 lug nuts on. With aftermarket wheels and extended shank Gorilla lug nuts I can only get one lug nut on. The studs are just off by a 1-2mm, not much but enough where if I force the lug nuts it'll damage the wheels or lug nuts. And I did this with just the tire carrier off the arm to make it easier to manipulate.
With a stock wheel and lug nuts I can get 2 lug nuts on. With aftermarket wheels and extended shank Gorilla lug nuts I can only get one lug nut on. The studs are just off by a 1-2mm, not much but enough where if I force the lug nuts it'll damage the wheels or lug nuts. And I did this with just the tire carrier off the arm to make it easier to manipulate.
Last edited:
Mine spare carrier came with 3 lug-nuts. They all fit nicely, no issues lining up.
I do not have this issue and I’m using the lugs for my Icon wheels.
