defroster vent screws (late 40) (2 Viewers)

[1911]

So, I am installing a Gamiviti dashboard accessory mount in my 12/79-build 40:

Dashboard Accessory Mounts — Gamiviti - https://www.gamiviti.com/dashboard-accessory-mounts

It is held by the two innermost machine screws in the defroster vents under the windshield. I thought that these would have been slot-head or JIS screws, but mine do not appear to be either; they look like they might have socket heads that have been filled in with paint, or maybe just plain round heads and a nut underneath the windshield frame? The hard top is on so I don't want to drop the windshield just to see if that might be the case. Here are photos:

Have you guys with late 40's seen these before, or is this some strange previous owner shenanigans?

 

[pb4ugo]

They are like push in or pull out type of plastic rivet, The screws had a metal clip that slides over the holes in the frame and the screws thread in to them.

 

[Living in the Past]

Those are stock on the 1/75+ defrost vents. Screws were used in the earlier steel defrost vents. Padded dash used screws across the bottom.

 

[65swb45]

Plastic rivets

 

[pb4ugo]

I've encountered retaining screws on a 77 w/s frame with plastic vents, and rivets on my 75 40.

 

[1911]

OK thanks guys, that is helpful.

Are new rivets still available from Toyota? If not I guess I’ll just use some appropriate-size generic replacement.

 

[GA Architect]

 

[1911]

View attachment 3983358

Thanks!