With photos, maybe?
My 40 is stalling out every now and then and I have to keep my choke pulled slightly even at running temps (160-170) or it will stall a little bit, or run kinda rough. I replaced the fuel filter and it still skips a beat sometimes and "coughs" (hiccups? I dunno) Basically it loses power for a bit.. Imagine pulling your foot off the gas and stomping back down on it immediately.
Is it running too rich? My "comfortable" idle speed is around 1k-1200rpm. It stalls ocassionally if it's less than that. When i adjust the choke it takes a couple seconds or so before it reacts, and sometimes it flip flops a little bit between a lower and higher idle speed.
Any ideas?
My 40 is stalling out every now and then and I have to keep my choke pulled slightly even at running temps (160-170) or it will stall a little bit, or run kinda rough. I replaced the fuel filter and it still skips a beat sometimes and "coughs" (hiccups? I dunno) Basically it loses power for a bit.. Imagine pulling your foot off the gas and stomping back down on it immediately.
Is it running too rich? My "comfortable" idle speed is around 1k-1200rpm. It stalls ocassionally if it's less than that. When i adjust the choke it takes a couple seconds or so before it reacts, and sometimes it flip flops a little bit between a lower and higher idle speed.
Any ideas?