I have decided to stop being a lazy ars and get this over with . I was reading this thread and just wanted to verify the flushing process since this is my first time.
So guys, is this right? Are there any other steps I need to be doing? BTW: where is this engine block drain plug/bolt (12/14 mm)? I can't figure it out from the picture, is it on the driver or passenger side?
I appreciate all/any inputs
- Drain coolant from the engine block.
- Drain coolant from the radiator
- Start up the engine, turn on the heater at max and wait until clear water coming out through the engine block/radiator plug hole, then turn off the engine.
- Wait until there's no more water coming out through any of the plugs.
- Fill it up with mineral free water and drive it for couple weeks.
- Then drain it again and fill it up with 50/50 with toyota red coolant with water.
- Drain it again in couple weeks and this time 100% toyota red collant.
So guys, is this right? Are there any other steps I need to be doing? BTW: where is this engine block drain plug/bolt (12/14 mm)? I can't figure it out from the picture, is it on the driver or passenger side?
I appreciate all/any inputs