Color Paint Codes 1977 FJ40

[ascalla]

Hello Everyone,
I am about to begin the body work on my restoration of a 1977 FJ40 California Model.
I know the body paint code is 532 Mustard Yellow as listed on the option sheet inside the glove box wall.
However, I am still confused as to the proper white color for the Hardtop and front light grille.

Can anyone assist?
Thanks
Albert

 

[78fj40mg]

It is Cygnus White, Hard Top, Front Grille, the code is #T-012.

 

[ascalla]

It is Cygnus White, Hard Top, Front Grille, the code is #T-012.

THANK YOU!!

 

[78fj40mg]

Cruiser Color Codes

 

[GA Architect]

Just had my top and bezel painted with the T-012.

 

[Landpimp]

Can you snap a pic of the option sheet in the glove box? I don't think I have ever seen one. I have seen the port sticker in the glove box, it has some codes and check boxes but didn't think the paint codes were on it. the paint code should be on the firewall Vin plate.

But its early and maybe I am confused

Hello Everyone,
I am about to begin the body work on my restoration of a 1977 FJ40 California Model.
I know the body paint code is 532 Mustard Yellow as listed on the option sheet inside the glove box wall.
However, I am still confused as to the proper white color for the Hardtop and front light grille.

Can anyone assist?
Thanks
Albert

 

[ascalla]

Can you snap a pic of the option sheet in the glove box? I don't think I have ever seen one. I have seen the port sticker in the glove box, it has some codes and check boxes but didn't think the paint codes were on it. the paint code should be on the firewall Vin plate.

But its early and maybe I am confused

Sorry for the late reply. The FJ is at the shop, going rough some of the restoration. I will take a picture next time I pass by. However, I believe you are right as to not showing the paint code, but will verify.

 

[sggoat]

Just had my top and bezel painted with the T-012.
Anything special about the prep for the top paint?(being fiberglass)

 

[CRZR45]

This is ppg brand Cygnus white color code

 

[GA Architect]

They really didn't want to paint it, being it is fiberglass....but they sanded, prep'ed and laid a few coats of paint down on it. Looks good to me.