Clutch fork pivot bolt torque (1 Viewer)

[ERNRAM]

Howdy,

Looked around for the bolt torque for the fork ball standoff.

Any guidance?

Thanks
Ernie

 

[cruisermatt]

500 ft-lbs

 

[ceylonfj40nut]

500 ft-lbs

Wow. Never realized it was that high!!

 

[cruisermatt]

I like to leave them finger tight, install the engine, bellhousing, transmission etc into the vehicle, then put a 20ft breaker bar on that bolt and use the forklift to lift on the breaker bar to torque the bolt.

 

[B y r o n]

If you can't find a listing for a specific torque, measure the thread size and look up standard torque value for that size thread and material.

 

[ceylonfj40nut]

I like to leave them finger tight, install the engine, bellhousing, transmission etc into the vehicle, then put a 20ft breaker bar on that bolt and use the forklift to lift on the breaker bar to torque the bolt.

Matt, your kidding right??

 

[cruisermatt]

Matt, your kidding right??

Yeah CD

Its a M8 bolt. Hand tight with open end 12mm wrench is fine

 

[3_puppies]

Matt, your kidding right??

wasn't it obvious?

 

[ceylonfj40nut]

Matt was using Yoda speak. I was not sure. The forklift gave me a hint.

 

[ToyotaMatt]

RED Loch-TITE and 3/8" Battery IMPACT tight ............