Delta VS
Supporting Vendor
Howdy all. Finally getting this project off the back burner.
Ram mount is already figured out, SwitchPro prototype is printing now, what other things would you like to mount in this location? It's a 2-piece assembly that sandwiches the OEM dash after removing the clock, so it's fairly stout. Putting something like a full size tablet would be too much though, so keep that in mind when imagining things for this spot (might work for something like that if used in conjunction with a Ram ball on the shifter console, using two arms to keep tablet super steady??). MOST things can probably be handled by the ram mount (including one of those swivel-y gyro type boat cupholders, swoon), but SwitchPro mount is a nice integrated type thing that keeps it within reach of the fingertips.
Will add ideas to the poll as they are mentioned.
Wire management is already in place to run wire through the mount for a clean setup, just not utilized in pics.
Ram mount is already figured out, SwitchPro prototype is printing now, what other things would you like to mount in this location? It's a 2-piece assembly that sandwiches the OEM dash after removing the clock, so it's fairly stout. Putting something like a full size tablet would be too much though, so keep that in mind when imagining things for this spot (might work for something like that if used in conjunction with a Ram ball on the shifter console, using two arms to keep tablet super steady??). MOST things can probably be handled by the ram mount (including one of those swivel-y gyro type boat cupholders, swoon), but SwitchPro mount is a nice integrated type thing that keeps it within reach of the fingertips.
Will add ideas to the poll as they are mentioned.
Wire management is already in place to run wire through the mount for a clean setup, just not utilized in pics.