Builds '81 Trekker ReDistruction (6 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Tried to pull a stud from the booster Andy gave me and sheered it right off.
IMG_20180601_203112.jpg

Did some internet digging and found you have to separate the booster to get to the studs. Beyond my paygrade.

Did some more digging and found the 2wd pre-Taco trucks have a dual diaphragm, large diameter booster with long studs which can be used with my factory spacer mentioned above.
toyota-89-95-2wd-dual-diaphragm-brake-booste.max-600x600.jpg


For now, to keep moving forward I reinstalled the original booster along with an 80 series master.
Cleand and antiseazed all the hard brake lines and reinstalled them too.
IMG_20180601_201725.jpg
 
Is that the inside of your new garage already?
Sheesh, maybe, what's it to ya?

Sux actually! The first oil change I did in there, I used a drain pan I had not used before and that happened.

I'll hit it with some Simple Green and scrub it up if it helps you and @fireball feel better :flipoff2:
 
Sheesh, maybe, what's it to ya?

Sux actually! The first oil change I did in there, I used a drain pan I had not used before and that happened.

I'll hit it with some Simple Green and scrub it up if it helps you and @fireball feel better :flipoff2:

It's like the first dent! It sucks but it's bound to happen!!
 
It's got hydrolics! Brakes are plumbed and I bled the system solo.
I noticed there is no bleeder on the LSPValve on this old truck. No problem, good solid pedal!
New clutch master and slave are plumbed and working, I also bled this solo :flipoff2:

IMG_20180605_113341.jpg
 
Last edited:
Nice bumper!
Did you make it?
Or was it a kit?


Don't worry I can't think any less of you if it was a kit. ;)

It's going to fit the exposition look perfectly!
 
Nice bumper!
Did you make it?
Or was it a kit?


Don't worry I can't think any less of you if it was a kit. ;)

It's going to fit the exo look perfectly!
Trail Gear $500 shipped, hard to pass up.
Also considering a more stock look.
IMG_20180614_144228.jpg
 
Last edited:
I like B as well, but you need something up there.

The stinger is a bit overkill
 
The stinger add a lot of srtenth to that bumper. It will also be hard to cut it off and blend the tube without it looking hacked up.
 
  • Like
Reactions: caz

Users who are viewing this thread

Back
Top Bottom