Wanted 80 Series Factory Upper/Lower Reinforced Hatch and Swingout (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 12, 2019
Threads
13
Messages
107
Location
The Dalles, Oregon
Vehicle Model
  1. 80 Series
Location
Oregon United States
Hello,

Unlike most folks, I really like my factory swing out. Unfortunately I had a good smack on the tire while the car was being worked on elsewhere. It looks like I will need the following to get things repaired:

-exterior swing out parts; arm and both QP mounts (pretty sure this is one assembly)
-Latch Plate for lower tail gate
-Upper rubber grommet plate for upper hatch.
-Upper hatch, reinforced
-Lower hatch/tailgate, reinforced

Happy to pay, just need to source parts. As rust free as possible, please! Willing to travel within reason.
IMG_7855(1).jpg
 
Always wondered what would happen if mine got hit. Time to think about a rear Slee...
 
Hello,

Unlike most folks, I really like my factory swing out. Unfortunately I had a good smack on the tire while the car was being worked on elsewhere. It looks like I will need the following to get things repaired:

-exterior swing out parts; arm and both QP mounts (pretty sure this is one assembly)
-Latch Plate for lower tail gate
-Upper rubber grommet plate for upper hatch.
-Upper hatch, reinforced
-Lower hatch/tailgate, reinforced

Happy to pay, just need to source parts. As rust free as possible, please! Willing to travel within reason.
View attachment 3476792
just get USDM upper and lower hatch then make your own reinforcements for the top and bottom latches. Easy, no welding, use a 3/16 Steel Flat Bar from Home Depot. This is what I did for my USDM truck when I installed the jdm rear tire carrier (reinforced all 4 pts).

IMG_7138.jpg
IMG_7643.jpg
 
I have an upper and lower tailgate with all the internal reinforcing, from a hdj80 not sure of the yr.
gold in color. Just putting this out there i'm in Atl.
 

Users who are viewing this thread

Back
Top Bottom