350 Chev (2 Viewers)

[Fairgame]

Has anyone put a 350 Chev in their cruiser? I have the opportunity to buy a nearly new one for $2000 and could source a manual transmission to suit.

 

[ClassyJalopy]

Has anyone put a 350 Chev in their cruiser? I have the opportunity to buy a nearly new one for $2000 and could source a manual transmission to suit.

what is wrong with the engine in your cruiser?

 

[Trunk Monkey]

Search for LS swap, there's been 2 I can think of.

 

[Fairgame]

what is wrong with the engine in your cruiser?

I have a cruiser without an engine or gearbox and a mate of mine has a new 350 so thought it might make for an interesting project?

 

[ClassyJalopy]

Absolutely - try it out. Are we talking about an old school carburetted 350 or a newer LT generation or even an LS? What transmissions are you considering?

 

[Patassa]

A Landcruiser with the reliability of an old chevy pickup truck? What could go wrong, lol.

 

[MongooseGA]

A Landcruiser with the reliability of an old chevy pickup truck? What could go wrong, lol.

An old Chevy truck will run like s***, but it'll do it forever.

 

[willyroo]

Search for LS swap, there's been 2 I can think of.

The only ones I could find was this one:

Engine/Transmission project

Hello All, first post :) Not sure if I am posting in the right section. Here we go: I am doing a brand new E-ROD LS3 engine with a Magnum T-56 6-speed manual transmission swapped into a 2000 Land Cruiser US Spec. The car will be %100 for street use, I'll think of off-road build later. And...

forum.ih8mud.com

And this one:

Another LS Swap: L92 & 6l80e into a '94 LC

I have completed the swap. I bought an L92 & 6l80e from the local junkyard. Was pulled from a 2007 Yukon Denali. Everything functions as it should. There have been no modifications to the interior of the rig that would indicate the change. Gauges work, trans shifts as it should (with sport/tow...

forum.ih8mud.com

Here in the land of Oz, (on LCool RIP) there was a well known supercharged LS into a 105 (replacing a 1FZ-FE), which has a solid front axle.

Mark's adapters does make a kit, however it's for LS motors into 80 and 105 - not the 100 (with IFS).

LS swap into 200 series

Has anyone swapped a LS/LT GM motor and either 8L90 or 10L90 trans into a 200 series? I know it's been done to the older LC/ LXs, but I'm looking for info on doing it to a 200 series. Or info on a shop that would do it in Colorado. Appreciate it.

forum.ih8mud.com

 

[excessive]

2UZ >350

 

[thatcabledude]

2UZ >350

Can you do this with a 2uz?

Yeah, didn’t think so.

 

[iliketrucks]

An engine with few electronics, an iron block, and iron heads? Sounds like what a land cruiser should have, if you ask me.